How To Hack Wifi Using Aircrack-ng In Termux Without Root?
The network software package called Aircrack-ng for 802.11 wireless LAN includes a detector, packet sniffer, WEP and WPA/WPA2-PSK cracking and analysis software. It works with any wireless network interface controller whose driver can sniff 802.11a, 802.11b, and 802.11g traffic and provides raw monitoring. When cracking WEP and WPA/WPA2-PSK keys, Aircrack-ng uses a variety of methods. A general purpose tool called Airbase-ng is intended to attack the client rather than the actual access point. Airdecloak-ng removes WEP spoofing from the packet capture file. A rule-based wireless disabling tool is called Airdrop-ng. The WEP protection standard is used by wireless networks, and Aircrack-ng is a great tool to use on these networks. The only problem is that WEP was declared obsolete in 2004. In Aircrack-ng, some routines work on the WPA network, but the standard is no longer used and the utilities don’t work either. .
Step 1:
Enable the wireless interface in monitor mode. The purpose of this step is to enable monitor mode on your card. Your tag can listen to every packet in the air while in monitor mode. Depending on the driver you are using, there are several steps to take to enable monitor mode. Run the following command to determine the driver (and the appropriate course of action to follow.
2nd step:
On computers with Ralink, Atheros and Broadcom wireless cards installed, the operating system responds:
Step 3: Installing madwifi-ng to hack wifi
Step 4: Start collecting authentication handshake data with airodump-ng
Step 5:
To unauthenticate the wireless client, use airplay-ng.
Step 6:
At this step, the wireless client is notified that it is no longer connected to the AP. Then, ideally, the wireless client will re-authenticate the access point. Re-authentication produces the 4-way authentication handshake we want to achieve. You define a currently connected client based on the output of airodump-ng in the previous step. For the next part, you need the MAC address. Open a new console window and type:
Step 7:
To decrypt the pre-shared key, run aircrack-ng.
Step 8:
Inside:
The password W. lst is the name of the dictionary file. If the file is not in the same directory, write the full path. The name of the set of files containing the collected packages is cap. In this example, you’ll see that we’ve included many files that use wildcards. When no handshake is detected, here is the normal output:
Step 9:
Aircrack-ng will now start trying to crack the pre-shared key. This process may take a while, even several days, depending on your CPU performance and the size of the dictionary.
The pre-shared key can be successfully cracked using the following method and Hacking Wifi with Aircrack-ng in Termux without root is now successful:
Note:
This article is for educational purposes only.
Enjoy 🥰.
